FREELOVE Concrete Serving Trays for Perfume Weed Jewelry Food, Decorative Tray Bath Vanity Counter Bathroom Car Coffee Table(Grey F, Oval 4.7'' by 11'')

Product Information

Using five parts builder’s sand and one part cement, mix up some mortar and place a thin layer beneath the shower tray. Use a spirit level to ensure the tray is completely level and press it into place. Leave for 24 hours to set. Through the access hatch you positioned next to the tray, connect the waste trap to the outlet pipe (it is a good idea to keep the access hatch for future maintenance if required). It is important that you take the time to properly fit your shower tray as there are many potential issues if this is not done correctly. If the shower tray is not fitted correctly there is a risk of leaks, water damage, water stains, plaster damage, damp, wood rot to flooring and floor joists, water pooling, poor drainage and damage to the tray. When learning how to lay a shower tray on a wooden floor, you will need to mark the area where the tray will stand. Next, replace the floorboards within that area with a minimum of 18mm marine ply.

Cut a hole for the shower tray waste. Ensure your measurements are accurate and once completed, proceed with assembly. When you have seen that everything is in the correct position, attach the waste to the shower tray and then connect this to the trap. Concrete floors are easy to maintain, affordable and long-lasting. This makes them the ideal choice for areas of your home that have high traffic. They also look incredible and are a great talking point with visitors.There will be two rubber washers attached to the waste (one for above the shower tray, and one for below), remove both.

If you suffer from mobility issues this may not be the best option for you as your shower tray will be higher than usual. Want to know how to install a shower tray on legs? Just use the following guide: Remember to properly prepare the space before beginning, then follow the below steps to achieve great results: For flawless results, wipe away any excess sealant and finish putting the trap together according to the manufacturer’s guidelines.You will need to ensure there is access to the waste pipes in the floor beside the tray. Using a jigsaw for accuracy, cut an access hatch. However, doing this also brings risks; in removing the old tiles, you must be careful not to damage any waterproof membranes over the boarding beneath the tile. Alternatively, if the tiles have been discontinued, then there is little choice but to replace the entire tile in the shower enclosure for effective protection from water damage. How much would a tradesperson charge to install a shower tray? Then, replace the rubber washers, hold the bottle trap under the shower tray waste hole and screw the upper piece into position. It can be difficult to prevent tile damage during this process as for correct shower installation, tiles are always fitted after the shower tray. This helps to prevent water leakage and weak spots. If the tiles have not been discontinued, you could consider carefully removing the lower levels, directly above the tray, then replacing the tiles after installation. Create some mortar by combining five parts builder’s sand and one part cement. Then spread a thin layer under the shower tray.